UG NX 6.0.2.8 graphics performance, Windows 7

[hiroman]

While selecting any face/solid, I am experiencing quite a slow graphics performance response from UG. Everytime I place the cursor on a face with or without translucency, it takes about 5 seconds to become selected while it changes color from its face color to the active or selected color.

It is really annoying because it happens every single time I select a solid. I tried the "Visualization Performance" under "Preferences". Disabling Translucency and Backface Culling helps a little, but the problem is still there.

I have UG NX 6.0.2.8 64 bit on Windows 7 (64 bit too). The graphics card is a Nvidia GeForce 8800 GT, which can handle DirectX 10.

Any help is much appreciated!

Will Kumazawa
Mechanical Engineer

 

[JohnRBaker]

First go to...

Preferences -> Selection...

...and check the value of the 'Rollover Delay' setting in the 'Highlight' section of the dialog. Try setting it to '3'.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[hiroman]

Thanks a lot for the reply! I'll try it on Monday back on work.

Cheers!
Will Kumazawa
Mechanical Engineer, Graduate Student
The University of British Columbia