UG NX2 VIEW FIT

[fsi]

I have a problem with UG NX2 FIT & Replace View for some parts. It does not show the part, It shows a blank screen.
But orient View works. Any body has had this problem?
thanks, fsi

 

[demco]

I've noticed the problem also when I use view--> operation--> rotate, as soon as I rotate the view, it dissapears, and I cannot get it back, not matter what. Anyone else run into this?

-Derek
DL Engineering Services

specializing in CAD Design Consultation Services

http://www.dl-engineering.com

 

[sociallyinept]

I am using UG NX and don't see any of those problems. Perhaps UG has a patch. I would check with their tech support. Also, make sure that the box labelled "Fit" is checked so that it does fit the view to the screen. Good luck.

 

[fsi]

sociallyinept
Where is the box labelled "Fit" ?
Thank you
fsi