I am a beginner of UG. I would like to learn about simulation of kinematics such as linkages, spring etc. Please let me know the basic how to make my simple mechanism in motion.
I started using the mechanism package about 5 years ago. First, it's a more advanced package which should be used after knowledge of UG modeling & assembly. With that said, the best advise I can offer (besides using a manual) is to start SIMPLE. For example: create a simple line / create a link of that line / create a revolute, fixed to the end point of the line, at "constant" motion / enter "articulation" and run the revolute 10 steps at 1 deg per step. If you get this to work - provo!! You should be successful building each joint independently before you attempt two joints in a single part. Lines and arcs are easier and faster to learn with than solids.