Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
UG_english.def file
- Thread starter ediushu
- Start date
First, you must be logged in as administrator. You then locate the UG english file (on my computer it is "Program Files\EDS\Unigraphics NX 2.0\UGII\ug_english.def"
. Open this file, scroll down (or use edit-find: wave geometry) until you see the section on interpart modeling. You then set the toggle "Assemblies_AllowInterPart: yes". After the change is made, EDS recommends you verify that the change is correct by running 'ug_validate -g ug_english.def'.
Before I make ANY changes to the ug_english file, I save a copy of the original as backup. I hope this helps!
. Open this file, scroll down (or use edit-find: wave geometry) until you see the section on interpart modeling. You then set the toggle "Assemblies_AllowInterPart: yes". After the change is made, EDS recommends you verify that the change is correct by running 'ug_validate -g ug_english.def'.Before I make ANY changes to the ug_english file, I save a copy of the original as backup. I hope this helps!
- Thread starter
- #3
- Status
