Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ultimax comment character?

Status
Not open for further replies.
HellBent

HellBent

Automotive
Sep 29, 2002
130
Hi all...what character do the Ultimax controls (2 and 3) recognize for comments within a nc file? I've tried putting my notes inside parentheses but no luck. Do they need a line #?...guess I'll try that.

Take care...
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Try the asterisk (*). I have seen this work on other non-fanuc controls.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

johnchrc
  • Locked
  • Question
Necessity for Thread Reliefs - And Comments on thread relief issue 2
Replies
16
Views
260
johnchrc
johnchrc

Part and Inventory Search

Sponsor

Back
Top Bottom