erismy
Mechanical
- Mar 12, 2013
- 1
Dear all expert ABAQUS,
How to model NITINOL wire for example 0.51mm diameter in suspension cantilever beam.
I have successfully model in in geometry but not successfully run ABQ_SUPERELASTIC_N2D .
I am still not understand where to run subroutine file ?
There is 2 encastered Boundary condition with the tip of cantilver is fixed with the concentrated load.
How to model NITINOL wire for example 0.51mm diameter in suspension cantilever beam.
I have successfully model in in geometry but not successfully run ABQ_SUPERELASTIC_N2D .
I am still not understand where to run subroutine file ?
There is 2 encastered Boundary condition with the tip of cantilver is fixed with the concentrated load.