SrGilberto
Mechanical
- Oct 13, 2004
- 132
Hello all,
(I use Pro/E Wildfire 2.0)
In drawing mode, when I select "View" then "Drawing Display" then "Edge Display", I get a pop-up menu. On the pop-up menu there is a selection "Highlight Mod". When I select that there are certain edges that become highlighted (they turn bold blue).
My problem is that I've not seen any selection that allows me to un-highlight the model/edges. What I've been doing to redraw the views without the highlighted edges is to save the drawing then erase it from session then bring it back up again. Is this weird? Am I overlooking something that is incredibly obvious, but just can see it?
Thank you in advance for your assistance.
Regards,
SrGilberto
(I use Pro/E Wildfire 2.0)
In drawing mode, when I select "View" then "Drawing Display" then "Edge Display", I get a pop-up menu. On the pop-up menu there is a selection "Highlight Mod". When I select that there are certain edges that become highlighted (they turn bold blue).
My problem is that I've not seen any selection that allows me to un-highlight the model/edges. What I've been doing to redraw the views without the highlighted edges is to save the drawing then erase it from session then bring it back up again. Is this weird? Am I overlooking something that is incredibly obvious, but just can see it?
Thank you in advance for your assistance.
Regards,
SrGilberto