Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Underline Lineweight in a Note

Status
Not open for further replies.

sauersjm

Mechanical
Jan 25, 2007
12
0
0
US
I just recently started to have this problem. When I create a note and choose to have it underlined, the lineweight of the underline is very thick. Any ideas on where to adjust this?
 
Replies continue below

Recommended for you

It's controlled at the font level. Try using a different font or it could be the graphics. So make sure your are using the correct drivers and certified card.

If you do a print of file is the underline still think? If not then its just a graphic issue.

Regards,

Scott Baugh, CSWP [pc2]
faq731-376
 
Status
Not open for further replies.
Back
Top