Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UNDOING

Status
Not open for further replies.

112275

Marine/Ocean
Jan 8, 2003
58
Can the Undo cammand be modified so that only commands are undone and not veiw changes?
 
Replies continue below

Recommended for you

In 2006 there's something new...? but inclusive the viewchanges. I don't know it exactly.

In 2004 You can jump more than 1 step back, but inclusive the viewchanges.

In two words, no. [wink]

Lothar

ADT 2004
ACAD 2002
 
Thanks, and excuse the spelling mistakes. Its early.
 
undo >
control (c) >
combine (c) >
Combine zoom and pan operations? [Yes/No] <Yes>: No >


maybe that will work???
 
Nope, didn't work. Thanks anyway. I hate the view undo, It should be a separate command like in other programs I won't mention.
 
I was thinking Solidworks. I hope I don't get banned.:)
 
Hehe. Don't worry this is eng-tips forum not the AUGI forum. tsk tsk
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor