Undold Surface

[cadddict]

Hi All
Can somebody tell me if there is afunction in NX4 to unfold or develop complex surfaces.if there is where do I find it?We have a Mach3 Bundle BTW

 

[JohnRBaker]

While I can't verify whether this is part of your Mach bundle or not, try the following;

Go to Start -> All Applications -> Sheet Metal -> Forming/Flattening...

When the dialog comes up hit OK and then go to Tools -> Flat Pattern... and follow the dialogs from there.


John R. Baker, P.E.
Product "Evangelist"
NX Product Line
UGS Corp
Cypress, CA

http://www.ugs.com

 

[cadddict]

Thanks John

The solution you suggest is from the Advanced Sheetmetal Module...I think we might have that module on one of our workstations....Thanks again