Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Unfold

Status
Not open for further replies.
InventorGod

InventorGod

Mechanical
Nov 7, 2006
27
Does Inventor have an unfold command, I've never used it so I don't know if there is one, but I need to unfold a part and it's not ours so we can do it to the part.SO what I need is to draw the part in 3d then unfold it to a blank
 
Replies continue below

Recommended for you

Sort by date Sort by votes
never mind, I found it, it's called flat or flatten in mine
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ACarrier
  • Locked
  • Question
Fusion 360 Sheetmetal fill gaps and unfold
Replies
1
Views
77
Sparweb
Sparweb
DominicG
  • Locked
  • Question
Unfolder failure: location of problem bend?
Replies
2
Views
116
DominicG
DominicG
Audacity
  • Locked
  • Question
"unfolding" ellipsoidal surface sections
Replies
11
Views
104
jlcochran1
jlcochran1
ArtSmart
  • Locked
  • Question
How to unfold a section of a cone? 2
Replies
3
Views
117
rft
rft

Part and Inventory Search

Sponsor

Back
Top Bottom