Unfolded view in sheetmetal 1

[sudhakarn]

Hi folks,
I am back here after a long time.Need your support and expertise once again.When I unfold a sheetmetal part that is stamped, I am not getting the exact flat pattern.I just get the previous state before stamping. Is that how the application is defined or is it possible to get the exact unfolded view or the flat pattern?
Request your expertise pls.

 

[itsmyjob]

unfolded view... the explanation is in the name... unfolded. not sure flat pattern is working good on stamping. Maybe in aerospace sheetmetal?

Eric N.
indocti discant et ament meminisse periti ​

 

[sudhakarn]

Hi itsmyjob,
Thanks for your reply.I didn't check it in the aerospace sheetmetal.But I don't think its working in the generative sheet metal design. Can you pls validate it?