Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

uni 3740

Status
Not open for further replies.
Tagger

Tagger

Mechanical
Aug 10, 2001
47
I have an Italian drawing of a double end stud where in the material spec. has 10.9 UNI 3740. I assume the bolt should conform to Class 10.9. Can anyone steer me in the direction or give explanation for the Italian standard UNI 3740.
Thanks!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The classes in UNI 3740 correspond to ISO 898 and Yes, it's Class 10.9. The material should be galvanized steel, but I'm not completely sure about that.
 
Upvote 0 Downvote
It is highly unlikely that hot dip galvanizing or zinc electroplating (sometimes referred to as galvanizing by non-English speakers) would be specified with property class 10.9 fasteners due to the risks of hydrogen embrittlement.
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom