Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UNI equivalent

Status
Not open for further replies.

hngopal

Mechanical
Jun 17, 2005
13
IN
anybody know the SAE or DIN equivalent to the following designation is?

UNI 6682 - 70 (Fe R37)?

Alternatively, an online resource where one might get this information would be helpful also.

 
Replies continue below

Recommended for you

This is probably a 1970 version of
UNI 6682:1987 Prodotti finiti piatti di acciai laminati a caldo e a freddo. Lamiere e nastri destinati alla fabbricazione di tubi saldati. ["Hot and cold rolled flat finished steel products. Plates, sheets and coils intended for production of welded tubes."]
Available in Italian only, for 34 Euros: Perhaps buy, then use MatWeb's composition search.

I searched briefly online & also the 1979 edition of ASM's Worldwide Guide to Equivalent irons and Steels. No luck.

Try the links at the FAQ
faq330-286

Register at Key-to-Steel & try their free PowerDemo.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top