Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Unit conversion after FE modelling

Status
Not open for further replies.

jeram123

New member
Jan 9, 2012
32
hi all,

I have completed the creation of a complicated FE Model.But now only i came to know that i forget to do the unit conversion from inches to mm ...Is there any way through which i can do the conversion after fe modelling?

Thanking you in advance!
 
Replies continue below

Recommended for you

Make a group with ALL FEM
scale the group with correct scale factor.
remember to transform and not to copy.
regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor