Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Units T and M.T in nozzle load list

Thread starter julian89
Start date Jun 9, 2021

Status: Not open for further replies.

Jun 9, 2021

julian89

Mechanical

Hi ladies and gentlement,

I recently stumbled upon a drawing from 1997 with units of nozzle loads stated as "T" for force and "M.T" for moments. The vessel is delivered by Babcock. Are these given as tonnef and.. tonnef × meters? Any one familiar with this notation?

I haven't seen this before, and can't verify the units in the calculation reports since they haven't done nozzle load calcs.

Thanks! Have a nice day.