Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UNJ form nuts

Status
Not open for further replies.

WightRob

Aerospace
May 11, 2005
6
Can anyone recommend a UNJF nut (standard hex, full height, non-locking)suitable for use with a NAS6708 bolt. The nearest I have found is a NASM315 but this does not have the "J" thread form.
 
Replies continue below

Recommended for you

Robatukes...

There are lots of self locking nuts with this thread style, such as... MS21042-thru-MS21046 & NAS1805 & NAS1805.

Do You absolutely need a plain hex nut [not self locking]?

Regards, Wil Taylor
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor