Updating and external reference synchronization

[jopal]

I have an assembly with 3 sub assemblies. At the main assembly I have a parameter to control the amount of a feature I require (a hole). In each catpart of each sub assembly I have a reaction to activate/deactivate the amount of holes. The holes are in there own part body then removed from the main part body. When I change the parameter at the main assembly once, all files update. Then when I change it again, the middle sub assembly does not update. I have to activate the catpart, update, then update the main assembly again. If I do not do the remove and run the main parameter, everything update perfect.

All parameters and features are published.

Any thoughts?

 

[DBezaire]

What is the active part/assembly when you modify the parameter the second time? Are you sure the Top level assembly is active?

Regards,
Derek

 

[jopal]

Yes. If I click the top assembly, it doesn't ask for an update. If I double click a sub assembly, the double clice the top assembly again, it will update. If I repeat this process, it asks for another update. Then it is fully updated.

 

[jopal]

By changing my reaction over to rule on that specifc sub assembly, it updates perfectly. It's strange that all the other ones work expcept for this one.