Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

urethane flame spread

Thread starter mesadave
Start date Apr 5, 2010

Status: Not open for further replies.

Apr 5, 2010

mesadave

Materials

I am looking to test a ether based urethane film to ASTM E 84 but before spending $1000 for the test would like to know if it will have a flame spread of less than 25% - I researched on the web but could not find where one had been tested and reported on. Any ideas on the chance of it passing?