Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

User Defined Nodes Numbering

Thread starter meshparts
Start date Oct 27, 2005

Status: Not open for further replies.

Oct 27, 2005

meshparts

Mechanical

Hi,

I have an automaticaly meshed model that I want to use as superelement. Now I wish that the master nodes of the superelement are consecutiveley numbered from 1 to the maximum master node number.

I tried to use node number offset for selected nodes but it don't work, since the command NOOFFSET,NODE applies for the whole nodes.

I would appreciate any help on this topic.

Alex