cocobob7
Mechanical
- May 19, 2011
- 1
New to CircuitWorks environment. Can read in Pads assemblies fine.
Having an issue only with generating a part file (board outline) that can be read by Pads. I've changed the names of the extrudes and thru holes per SW recommendation. Is there a secret to writing the file that I haven't discovered? Any recommendations for creating a clean file for pads to read would be appreciated.
Having an issue only with generating a part file (board outline) that can be read by Pads. I've changed the names of the extrudes and thru holes per SW recommendation. Is there a secret to writing the file that I haven't discovered? Any recommendations for creating a clean file for pads to read would be appreciated.