I'm trying to create a law-defined curve. It has "left" and "right" parts
Knowing that there are "if" expressions in NX I tried using it, but when I create a curve using these laws constant function is displayed. Is it not possible to use "if" clauses, or am I doing something wrong?
In pic.1 are my expressions, pic.2 is what I get and how I create a curve, pic.3 is desmos variant of the "yc"
PS
I did this the stuff without using if clauses, but using two of them here creates not 4, but 8 expressions later and it snowballs into a mess of a calculation
Knowing that there are "if" expressions in NX I tried using it, but when I create a curve using these laws constant function is displayed. Is it not possible to use "if" clauses, or am I doing something wrong?
In pic.1 are my expressions, pic.2 is what I get and how I create a curve, pic.3 is desmos variant of the "yc"
PS
I did this the stuff without using if clauses, but using two of them here creates not 4, but 8 expressions later and it snowballs into a mess of a calculation
