moog3
Marine/Ocean
- Nov 29, 2022
- 67
I've been using NX for over 20 yrs, and there's always been a way to specify an input in inch units when working in a metric part.
way back when.... it was done by (IN)2.5 for 2 1/2 inches, then later it changed to (INCH)2.5 but now NX2007 neither of those work, but I did get it to work with 2.5inch
My question is.... how do I specify fractional inch inputs? I'm sure in the past i could say (INCH)5/8 and it'd know I meant 0.625
I tried a few ways but couldn't get it to work.
way back when.... it was done by (IN)2.5 for 2 1/2 inches, then later it changed to (INCH)2.5 but now NX2007 neither of those work, but I did get it to work with 2.5inch
My question is.... how do I specify fractional inch inputs? I'm sure in the past i could say (INCH)5/8 and it'd know I meant 0.625
I tried a few ways but couldn't get it to work.