Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

using mastercam to program a mazak lathe

Status
Not open for further replies.
pbboyd

pbboyd

Industrial
May 26, 2004
5
I have a mazak quickturn 28n lathe with a mazatrol controller.
does any know of a post processor for mastercam that will work??
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Contact your MasterCam reseller or check on the CD that was included with your software. One of those two places should solve your problem.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

paulcook
  • Locked
  • Question
Fusion 360 CAM VS MasterCAM 1
Replies
6
Views
832
RobWard
RobWard
S
  • Question
Turning a 410 S.S 15mm round bar to 12.7mm
Replies
6
Views
3K
Saman2002
S
T
  • Question
Why use a buildbotics controller
Replies
0
Views
42
thomas29
T
dogbural
  • Question
machining a long tube (380mm)
Replies
8
Views
3K
Gr8blu
Gr8blu
Ramadan Ahmed
  • Locked
  • Question
Good evening all I would like to
Replies
6
Views
544
mfgenggear
mfgenggear

Part and Inventory Search

Sponsor

Back
Top Bottom