Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

using promechnica but solving with the ansys solvers

Thread starter manker
Start date Sep 18, 2003

Status: Not open for further replies.

Sep 18, 2003

manker

Automotive

Hi, I am hoping that someone can help me out. I have Pro Mechanica and Structural Ansys and i am trying to mesh parts in Pro E and use the Ansys solver to solve on line , I keep getting an error that says can't find ansys solver check installation. i am able to output the ans file to ansys and run the file but i am not able to solve in Pro Mechanica with the Ansys solver is there a special config.pro file that i need . Thanks in Advance. Mike