21Pom
Mechanical
- May 1, 2010
- 131
Hi All,
I have a piece of RHS into which a 'V' shape is cut from one side to the roll of the other side. We then bend the RHS bringing the two sides of the 'V' together. A string line is then stretched between then ends of the RHS and the distance between the bend and the string line is adjusted to 40mm by allowing the RHS to flex downwards. In practice this works OK. In my part.ipt I place a sketch on the side of the RHS and draw the string line. I then bend the part together until the desired distance is met, however my drawing does not show the string line. I have added a sketch in the drawing file but this does not allow the parts to be projected onto the sketch so that a line can be drawn. Is there a way to achieve this?
Best Rgds,
Dave R.
I have a piece of RHS into which a 'V' shape is cut from one side to the roll of the other side. We then bend the RHS bringing the two sides of the 'V' together. A string line is then stretched between then ends of the RHS and the distance between the bend and the string line is adjusted to 40mm by allowing the RHS to flex downwards. In practice this works OK. In my part.ipt I place a sketch on the side of the RHS and draw the string line. I then bend the part together until the desired distance is met, however my drawing does not show the string line. I have added a sketch in the drawing file but this does not allow the parts to be projected onto the sketch so that a line can be drawn. Is there a way to achieve this?
Best Rgds,
Dave R.