Can anyone tell me if it's ok to route stainless steel tubing underground in direct contact with earth for instrumentation purposes? Or could you point me toward which standard I should be looking in? This is typical tubing used in instrumentation. 3/8"x20'x.032" ATP 304 304L
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Using Stainless Tubing Underground.
- Thread starter Mobivs
- Start date
MikeHalloran
Mechanical
If you just direct bury it, you will have to dig it up to replace it, and you will replace it someday.
If you put it in a conduit, you can pull a replacement tube without digging.
I'm not seeing the virtue of direct burial, except maybe in a sandy desert.
Mike Halloran
Pembroke Pines, FL, USA
If you put it in a conduit, you can pull a replacement tube without digging.
I'm not seeing the virtue of direct burial, except maybe in a sandy desert.
Mike Halloran
Pembroke Pines, FL, USA
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question