Using the draft feature - SW 2015

[jdmmech]

Hi there,

I am trying to create a draft on this part. See picture below. I have used the draft feature before but I cannot figure this one out. Any help is appreciated. Thanks!

 

[jdmmech]

I got it figured out but not the way I wanted to do it. I would like to set an end limit to the draft of where it would meet the face but instead I just played with the angle until it got close enough. And the angle is 77.47degrees.... This will work, but anyone have any ideas for future applications? Thanks again.

http://files.engineering.com/getfil...-bc7f-524e1fe2c7a8&file=DRAFTQUESTIONdone.png

 

[drawoh]

jdmmech,

This should go in forum559.

You kind of have to start your draft from the small end.

--
JHG

 

[jdmmech]

Good to know. My apologies.

 

[moon161]

Let the start face drive the rest, if it needs to be exact. You can apply a positive or negative draft angle.