A FERREIRA
Automotive
- Mar 14, 2023
- 1
Hello everybody,
I`m rather new to using adams/car, so excuse me if this is a stupid question. I`ve been trying to run the most basic kind of normal mode analysis using Vibration on my full car assembly, and no matter what I try I always get the same errors of "Static Equilibrium operation failed" and "Linearization failed". Adams message window tells me nothing other than the solver has aborted abnormally.
I hope this is just a rookie mistake from my part. Many thanks in advance for any input.
I`m rather new to using adams/car, so excuse me if this is a stupid question. I`ve been trying to run the most basic kind of normal mode analysis using Vibration on my full car assembly, and no matter what I try I always get the same errors of "Static Equilibrium operation failed" and "Linearization failed". Adams message window tells me nothing other than the solver has aborted abnormally.
I hope this is just a rookie mistake from my part. Many thanks in advance for any input.