V4 Layer problem

[atcoast]

Usually in the "list of LAyers" there are layers 0-254 listed. When I open our seed model only layers 0 and 4 are listed in the list of layers. But i can open the same model on a different scope and there fine. Dont confuse this with the layer filter. This is in the list of layers. Thanks Atcoast

 

[jackk]

It's been awhile since I used V4, but I seem to recall options to list all the layers or just the used layers. Was it on the bottom of the layer list panel?

 

[solid7]

What *exactly* is the "list of layers?"

I'm not sure I know what you mean. There is a list of layers under several of the layer sub-functions. Please be specific, as this could pertain to a filter, or it could be something else, depending on how you are seeing this "list of layers."




**************
Check out CATBlog!

 

[bradmac65]

"List of Layers" shows up when you select the 'Layer' function in V4, option 'Layer', and sub-option 'Analyze'. In the top right corner of the screen that comes up, there are options for 'All', 'Used', and 'Unused'. If only some of the layers are showing, the option 'Used' or 'Unused' is probably selected. By selecting 'All' you should see all available layers in the model (Layers 0-254).

 

[atcoast]

Thanks but it turned out to be a bug caused by a file during the installation of V4. It had nothing to do with "all, used, unused" thanks anyway.

 

[solid7]

That's why I asked about the "list of layers." It didn't sound typical...

Glad you got it worked out.




**************
Check out CATBlog!