Validation of Antisurge Valve of a Centrifugal Compressor using Dynamic Simulation in Aspen HYSYS

[waqasmanzoor]

Dear All,

I have to validate an Antisurge Valve of a centrifugal compressor using Dynamic Simulation in Aspen HYSYS. Does anyone have worked on a similar project?

Also I have to specify initial tuning parameters for the Antisurge controller. Please advise specifically for Aspen HYSYS software.

Thank you

 

[waqasmanzoor]

I am new to these types of calculations. Therefore, I reverted to this forum like I did for many of the other process engineering calculations

 

[SatputeAjay]

waqasmanzoor,

Please refer to below links to learn more about compressor dynamic analysis;

http://www.google.com/url?sa=t&rct=j&q=&esrc=s&frm=1&source=web&cd=1&ved=0CB0QFjAA&url=http://

http://www.aspentech.com/Compressor...ctu4HqKwcjNXECX-NzuVJDQ&bvm=bv.79189006,d.d2s

http://iom.invensys.com/EN/pdfLibrary/AppSolution_SimSci_DYNSIMCompressorMotorRestart_01-10.pdf

http://turbolab.tamu.edu/proc/turboproc/T12/T12147-173.pdf

http://www.diva-portal.org/smash/get/diva2:646827/FULLTEXT01.pdf

http://turbolab.tamu.edu/proc/turboproc/T6/T6pg123-132.pdf

http://www.gastechnology.org/Training/Documents/LNG17-proceedings/Instr-4-Vincent_Tirilly.pdf

Regards.

Ajay S. Satpute

 

[waqasmanzoor]

Dear Mr. Ajay S. Satpute,

Thank you very much for sharing the files and solving my problem

God bless you