valving in hydraulic operation

[ksuengrng]

Is there a valve available that would adjust the amount of flow in a hydraulic line, based on the signal received from an electronic device?&nbsp;&nbsp;<br><br>I am currently planning on running it into a PLC, but if a valve is available, then I would like to bypass the PLC.

 

[budt]

ksuengrng;<br><br>Look in the Designers Guide at <A HREF="

http://www.fpweb.com"

TARGET="_new">

http://www.fpweb.com</A>

to see a list of all manufacturers of flow controls. You should look at the ones listed as Proportional Flow Controls.<br><br>Regards:<br><br>Bud Trinkel<br><A HREF="

http://www.evansville.net/~fluidpwr"

TARGET="_new">

http://www.evansville.net/~fluidpwr</A>

<p>Bud Trinkel<br><a href=mailto:fluidpwr@evansville.net>fluidpwr@evansville.net</a><br><a href=

http://www.evansville.net/~fluidpwr>Fluid

Power Solutions</a><br>33+ years experience in hydraulic and pneumatic circut design, troubleshooting and training.