Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

VBA to Pull Total Surface Area and Volume for a Part of an Assembly?

Thread starter jdconnel
Start date Friday at 6:02 PM

Friday at 6:02 PM

jdconnel

Mechanical

I have started some VBA code.
I can get the part to open, but I am not seeing the correct syntax to save the Volume and surface area to a variable?
I have a few thousand parts that i need to extract this info from. Hoping for a scripting solution.
Coded in VBA for a while, but not done and integration with Solid Edge.

Thanks!