Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Vertical axis windmill blade design

Status
Not open for further replies.
Merlino

Merlino

Mechanical
May 21, 2008
5
Hi all
I wanna project a vertical axis windmill, which program do you suggest me to use to optimally design the blades?
I've seen ANSYS Blademodeler ( what do you think about it? any experience? any suggestions?
Thanks a lot
 
Status
Not open for further replies.

Similar threads

md_salem
  • Locked
  • Question
how to do share topology in the design modeler in Ansys Workbench
Replies
1
Views
197
Stick.
Stick.
andradesilva
  • Locked
  • Question
how to select a cross-section for a line built in Design Modeler in ANSYS workbench 2023 R1
Replies
0
Views
103
andradesilva
andradesilva
andradesilva
  • Locked
  • Question
problems validating design optimized geometry in ANSYS workbench
Replies
0
Views
71
andradesilva
andradesilva
andradesilva
  • Locked
  • Question
Design Modeler: How to reset worspace/window layout
Replies
1
Views
113
rickfischer51
rickfischer51
andradesilva
  • Locked
  • Question
How to measure the dimensions of a solid in Design Modeler (ANSYS Workbench)
Replies
1
Views
406
NRP99
NRP99

Part and Inventory Search

Sponsor

Back
Top Bottom