Video Card or SW ? - Continued

[arb6591]

Now, it's unbelievable.
Listen to that, when I open assy there is only SW background. When I open one of the parts, close it and go back to assy everything works perfect.
This is a one big mistery to me.
Anybody has any clues?
BTW where on the video card website I can find software settings so my GeForce4 acts like I believe Quadra ( SW recomended)
Thank you for all the input.

Andrzej

 

[ctopher]

Any more details? not clear to me your problem.
See

http://www.solidworks.com

for video cards supported.

 

[arb6591]

More details:
I have to open and close any part from my assy so it shows up in the graphic area.
If I do not do it, there is nothing visible on the screen, ctr+B, ctr+Q and ctr+R don't help.

 

[CorBlimeyLimey]

In your thread559-103473 you stated that the the driver you were using "worked before very well" ... so why did you change it? Roll your system back to that driver.

Also the website for the forceware you are looking for was posted by Bertus in the above thread.

from (the City of) Barrie, Ontario.

What happens if you get scared half to death twice?

 

[SBaugh]

This is your Video Card Driver. Roll it back to the old one or get a new driver according to the SW website See link above in ctopher's post.

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376

 

[Mindnumb]

Here are some info on softmodding.

Have done this on a couple og computers here at work, and it works all right, but we have used some older drivers, 44.something....

http://forums.guru3d.com/forumdisplay.php?s=&forumid=18

download the rivatuner program

http://downloads.guru3d.com/download.php?det=163

Read the readmefile, post again if you cant make it work, I´ll try and help.