Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IFRs on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

View Boundary by Break Line / Detail

Status
Not open for further replies.

DaveJFT

Automotive
Dec 5, 2012
60
Replies continue below

Recommended for you

Can you upload a picture of what the problem?

Sam Slivinski
Using NX 6
Manufacturing/Aerospace
 
Hi Sam,

Thanks for your reply. I came back to the problem after my lunch and realised I'd missed the key step of setting the Active Sketch View. I set this and redid my boundary curves and all is now working as described.

It's amazing what taking a break from a problem can do.

Thanks again,

Dave
 
That is what I was going to suggest as I have also gotten very frustrated with a problem trying to select curves and not been able to because they were not in my active sketch view. Also anyone else that sees this thread, another problem may be that the layer that line is in is turned off but is visible in the view. Therefore you can see it, but not select it.

Sam Slivinski
Using NX 6
Manufacturing/Aerospace
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor