Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

View Break Error...

Status
Not open for further replies.
DerkMc

DerkMc

Industrial
Apr 5, 2018
17
0
0
US
Using NX1915, I keep getting the error message shown below. I was able to semi-work around this by adjusting where the break is, but I can't figure out why it's happening.

Any help is appreciated!

Screenshot_2021-07-01_172720_wwto0v.jpg
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

CAD2015
  • Question
Drawing view multibody management............. 2
Replies
3
Views
41
ewh
ewh
CAD2015
  • Locked
  • Question
Save View in NX 2212............... 1
Replies
2
Views
16
CAD2015
CAD2015
wolverj82
  • Locked
  • Question
Detail/Break View Boundary
Replies
4
Views
34
wolverj82
wolverj82
loworange88
  • Locked
  • Question
Drafting - Break Out View Active Sketch issue
Replies
4
Views
24
jerry1423
jerry1423
Cyril S
  • Locked
  • Helpful tip
NX - Part Family - Error "The specified string contains a syntax error"
Replies
0
Views
16
Cyril S
Cyril S
Back
Top