Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Visual Basic drag boxes help

Status
Not open for further replies.

newprogrammer

Computer
Apr 5, 2009
1
Hi All, very new to this forum. Is this the place to ask about a solution i cant find while learning visual basic? Well here is the question if it is allowed. I am writing a small program that shows a series of square boxes, say 4 x 4
layout. I want to label each box (which i have figured out already) but would like to drag the box and replace it on different boxes. i,e move box upper left to box position lower left..just so i can sort it after it is laid out, as opposed to relabeling everything each time. Is this possible? Thanks for the help.
 
Replies continue below

Recommended for you

You might want to check out tech-tips.com - I think that is the name - which is a sister site to this. It is ALL about computers and programming.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor