WCS selection - inferred point: not working... 1

[Shadowspawn]

NX 5.0.2.2
Yesterday, the 'inferred point' selection option when placing/orienting the wcs quit working. Other options work (intersection, end point, etc...) but the inferred point doesn't. This is not part specific; I've tested on legacy and new part files w/the same failing results. Anyone have any ideas and/or solution to get this working again? As far as I know, no settings were changed...

As usual, thanks in advance...

Regards,
SS

CAD should pay for itself, shouldn't it?

 

[JohnRBaker]

In the 'Selection Bar' there is a section for 'Snap Points' and the very first icon toggles ON/OFF the Snap Point function itself. Make sure that that first icon, labeled 'Enable Snap Point', is actually toggled ON.

John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[Shadowspawn]

John,
...as usual, You Da Man! Thanks much and here's your star.

Regards,
SS

CAD should pay for itself, shouldn't it?