Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

WEDM tool path visualization problem

Status
Not open for further replies.
rafl

rafl

Mechanical
May 30, 2011
41
When I choose WEDM tool path visualization I always get a message "2D material removal is not supported ..." (see attached file)
Has anyone else ran into this and know of a solution?
 
Status
Not open for further replies.

Similar threads

MANox
  • Question
NXjournal: Eval.AskArc problem 2406
Replies
2
Views
779
MANox
MANox
K
  • Question
Sew: tool does not share a common boundary
Replies
3
Views
1K
cowski
cowski
Dbfoster24
  • Locked
  • Question
Shop Doc Variable for OVL of Tool Assembly? Also Tool Image?
Replies
0
Views
221
Dbfoster24
Dbfoster24
gluten02
  • Locked
  • Question
Can't figure out deform tool
Replies
1
Views
162
Toost
Toost
studiotreccani
  • Locked
  • Question
visula basic problem
Replies
1
Views
200
Anton Liubimov
Anton Liubimov

Part and Inventory Search

Sponsor

Back
Top Bottom