Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Weir made of PVC for pressure vessel

Status
Not open for further replies.
Timetraveller007

Timetraveller007

Mechanical
Jun 14, 2017
8
One of our clients asked us to investigate using PVC plate as weir inside one of our pressure vessels which is liquid-liquid separator. The intention is making it lightweight to do maintenance.

I am curious if anybody has experience with PVC internal parts for ASME pressure vessels.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
I saw the PVC trough inside the sour liquid process vessel.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

E
  • Question
Thin Walled Pressure Vessel
Replies
4
Views
1K
TGS4
TGS4
Virendra Patel
  • Locked
  • Question
Replacement of same pressure vessel part (HX bonnet) needs only R-1 report. 1
Replies
2
Views
243
rachnatbovo
rachnatbovo
kremenco
  • Locked
  • Question
Should the Jacket of a Cryogenic Vessel be considered as pressure vessel?
Replies
7
Views
176
LittleInch
LittleInch
mariolucas75
  • Locked
  • Question
ASME pressure vessel internal pitting weld build-up repair 1
Replies
7
Views
300
mariolucas75
mariolucas75
KevinNZ
  • Locked
  • Question
Removal of weld from internal vessel surface 5
2
Replies
33
Views
482
r6155
r6155

Part and Inventory Search

Sponsor

Back
Top Bottom