Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
Weld Between Points 1
- Thread starter jerry1423
- Start date
-
1
- Thread starter
- #2
I was able to find a way to do it, but I am still interested in hearing about a better way.
I used an ascii symbol and changed the aspect ratio using <Y2.5> and the character size using <C.9> and it looks good.
A<C.9><Y2.5>↔<Y><C>B
Jerry J.
UGV5-NX1899
I used an ascii symbol and changed the aspect ratio using <Y2.5> and the character size using <C.9> and it looks good.
A<C.9><Y2.5>↔<Y><C>B
Jerry J.
UGV5-NX1899
- Status
Similar threads
