Weld Groove tutorial in nx 7.5?

[designerabc]

Is there a tutorial on how to use the weld groove command in nx 7.5? I have tried to figure it out... but with no luck...

 

[JohnRBaker]

Have you looked at the NX Help files?

If not, when the 'Weld Groove' dialog is open, press the 'F1' key and the Help page will come up. Select the 'How To' link at the top of the page and it will take you to a step-by-step instuction on how to use this command.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[designerabc]

Thanks!!!