Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

weld symbols in drawings

Status
Not open for further replies.

kklinger

Mechanical
Feb 18, 2002
18
EU
In response to closed thread554-210324.

To remove the weld sequence # from the reference tail on a weld symbol created with Pro/Weld, you need edit the weld symbol and remove the reference text from the symbol. To edit a weld symbol, from a drawing, go to format->symbol gallery->redefine and select the symbol you want to edit. After editing, select "write" to save the updated symbol.

Note: the new symbol without the weld sequence will only be valid on new assemblies (i.e. existing assemblies using weld symbols created from Pro/Weld will not be updated and cannot be updated).

Hope this helps,

Kirk
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top