Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Weld symbols (UK BS8888)

Thread starter SiW979
Start date Sep 13, 2013

Status: Not open for further replies.

Sep 13, 2013

SiW979

Mechanical

Hi

I was wondering if anyone could tell me whether or not is acceptable to place weld symbols on ISO (or similar) drawing views? Or should all weld symbols be placed on the orthangonal views?

Many thanks

Si

Best regards

Simon NX 7.5.4.4 MP8 and NX 8.5 (native) - TC 8

http://www.jcb.com