Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

WF2->WF4 config.win not working

Status
Not open for further replies.

hygear

Mechanical
Apr 15, 2011
50
My company recently upgraded from Pro/Engineer WF2 to WF4. When the switch was made, I moved my config.pro and config.win files over to the new directory. My config.pro file seems to load fine and all of my mapkeys are available, but for some reason it will not load my config.win file with my custom menus.

Does anyone know what might cause this or how to work around it?
 
Replies continue below

Recommended for you

Hi

If you have , open config.win in Wildfire3 and save

Then try open whit Wildfire 4

regards

Wildfire is very nice, if you know,
how work with him
 
PTC recommends that config.win files be recreated between versions because of selection position changes.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor