wcssrobb
Mechanical
- Jan 16, 2006
- 1
Hello,
Does anybody have a sample .hol file that encompasses some kind of ANSI hole/thread standard. I have looked over the previous thread (thread554-114269 ) from UKIDOT and I am on the quest for the same info. I have learned how to set up the note but now have questions on adding the cbore and csnk symbols to the note, and how to get the system to recognize if there is/isn't a cbore or csnk? Any help would be greatly appreciated.
Thanks
Does anybody have a sample .hol file that encompasses some kind of ANSI hole/thread standard. I have looked over the previous thread (thread554-114269 ) from UKIDOT and I am on the quest for the same info. I have learned how to set up the note but now have questions on adding the cbore and csnk symbols to the note, and how to get the system to recognize if there is/isn't a cbore or csnk? Any help would be greatly appreciated.
Thanks