Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

What is the use of Vertical Offset command in SAFE12

Thread starter monver
Start date Aug 20, 2014

Status: Not open for further replies.

Aug 20, 2014

monver

Structural

I have noticed that by providing the vertical offset in SAFE 12 a very impressive 3d graphic display is generated. There is no physical change in the actual model as neither it effects the deflection values nor any slab moments. So I don’t understand why this command is there? Do anyone know what is the use of this command? I have to use release command in slab.