Wheel following a guide profile?

[monkeys]

hello all,

How do you get a wheel to run along a profile - in this instance a vertical profile which then starts to curve. In the assembly I can only mate the wheel to the profile of the straight or curve section.

How do i mate the wheel so that it follow the full profile path and not just the one profile surface.

Thanks in advance,

Callum

 

[SBaugh]

http://www.mikejwilson.com/solidworks/solidworks_files-02.htm

- Curve Driven Animation

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
faq559-716 - SW Fora Users