Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IFRs on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

whipped topping

Status
Not open for further replies.
Replies continue below

Recommended for you

Sort by date Sort by votes
forgot to say, nx8.03


sorry new in NX
regards
Erwin
 
Upvote 0 Downvote
Do you want help on how to to design a similar shape or is this something i don't understand ?

In case you really want to design a similar shape, the difficulty is the irregularity, i.e it is a simple task to design a sweep along a "helical" spline, but then make it irregular is probably more a task for the X-form command and some time spent.

Regards,
Tomas
 
Upvote 0 Downvote
I want to design the shape not the air ;-)
I have played around with cone reworked with x-form. I'm not happy with result.

sorry new in NX
regards
Erwin
 
Upvote 0 Downvote
What you need to do is take place whipped topping on a plate like it's shown in your picture, have it digitally scanned, and then download that scan into NX. :)
 
Upvote 0 Downvote
its not that hard of a model to create i cant do it at work but if i remember when i get home tonight i can whip it out. Sketch the outer profiles and connect with surfaces i have examples at home that i will upload to give you ideas

Ryan Lee
Design Engineer

If you can think it it can be modeled
 
Upvote 0 Downvote
"when I get home I can whip it out"? You're killing me on a few different levels, but I'll just chuckle at the whip cream pun.
 
Upvote 0 Downvote
Friday chuckles were implied

Ryan Lee
Design Engineer

If you can think it it can be modeled
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom